This Pin Chuck is used to hold a small workpiece using a 3/8" hole drilled in it. The chuck is made of steel rod that has a flat milled in it. The pin is placed on the flat, then the piece to be turned is pushed onto the rod. Rotate the piece clockwise on the rod a quarter turn and it locks into place. Turn it back and pull to remove after turning. This Pin Chuck can be held in a drill type key chuck, or in the Beall Collet Chuck.
|110106||3/8'' Pin Chuck||$17.95|
Copyright 2000-2014, Packard Woodworks Inc., All Rights Reserved